Define Constrain Label Direction |
|
|
Define the directions of the supports for a display purpose on screen. |
|
|
|
From the Main Menu select Boundary > Etc. > Define Constraint Label Direction. |
|
|
OptionsAdd/Replace: Add or replace the constraint label direction. Delete: Delete the constraint label direction. Label DirectionDefine the direction of the label of the support For example, a set-up such that local z(+) is defined for the bottom supports and local x(+) is defined for the left supports will display on screen as below. Note View > Display > Boundary Tab, the display of the directions of supports can be controlled by checking on and off. |
|