Plate Column Data for Checking

Assign predefined rebar data to the specific Sub-Domain for Plate Column Checking.

From the Main Menu select Design > RC Design > Plate Column Data for Checking.

First,  enter the name of the rebar input for plate column considering both Main Rebar and Distribution Bar:

 Plate Member

Select the Sub-Domain Name, Plate Force Option and the Main Rebar Direction for checking.

Sub-Domain Name : Predefined Sub-Domain which is defined as Plate Column (1D) can be selected. Click  to Add/Modify Sub-Domain

Note

Analysis result will be deleted if Sub-Domain is added or modified.

Plate Force Option 

Element: Uses the Internal forces calculated at each node of selected elements.

Avg. Nodal: Uses the average internal nodal forces of the contiguous elements sharing the common nodes.

Main Rebar Direction

Dir.1 : The section is checked using the bending moment in Dir.1 defined in Sub-Domain and the shear direction is also determined.

Dir.2 : The section is checked using the bending moment in Dir.2 defined in Sub-Domain and the shear direction is also determined.

 Rebar Data

Select rebar data defined in Rebar Input for Plate Column. Click  to Add/Modify Rebar Input for Plate Column.

: Add the newly entered data of the selected sub-domain.

  : Modify the previously entered data of the selected sub-domain. Design dialog is not closed when
                         modifying the data so that ‘Re-Calculation’ is possible without performing the design again.

  : Delete the previously entered data of the selected sub-domain.