Diagnostic Test Result
|
|
|
Adjustment factor resulting from the comparison of measured test behavior with the analytical model can be considered to calculate the load-rating factor based on the test result. |
|
|
|
From the Main Menu select Rating > Steel Bridge > Diagnostic Test Results |
|
|
Option Add/Replace: Add/Replace the rating option to the selected element for design Delete: Delete the rating option defined previously for the selected element Define Rating Position I: Enter the diagnostic test results only at i-end. J:Enter the diagnostic test results only at j-end. I & J: Enter the diagnostic test results at both ends. Load Test Measurement Auto-Calculation Strain / Displ.(I): Maximum strain or displacement measured during load test at i-end Strain / Displ.(J): Maximum strain or displacement measured during load test at j-end Note. Measured value can be entered as Strain or Displacement. It can be specified in Rating Parameter. Kb: Factor for the understanding of the load test results when compared with those predicted by theory. Refer to the figure below from Table 8.8.2.3.1-1 of The Manual for Bridge Evaluation, 2011. Values for Kb Note. When Auto-Calculation is selected, the Adjustment Factor is calculated as below.
K=1 + Ka Kb
where, Ka=εC/εT-1 εC = Maximum strain or displacement measured during load test εT = Corresponding calculated strain or displacement by the program User Input Adjustment Factor, K : Enter the adjustment factor directly from the manual calculation.
|
|