Enter the design code applicable for strength verification of SRC (Steel-Reinforced
Concrete composite) members.
From the Main
Menu select Design > SRC Design Parameter > Design Code.
From the Menu
tab of
the
Tree Menu select Design > SRC Design Parameter > Design Code.
The following dialog box is used to enter
the data:
SRC Design Code dialog box
Design Code
SRC design code (Default = SSRC79, refer
to Note 1)
Apply Special Provisions
for Seismic Design
Not available
: Enter the selection
and close the dialog box.
: Do not enter the selection
and close the dialog box.
Note 1
If the user does not specify the design code, the allowable stress design
(A Specification for the Design of Steel-Concrete Column, 1979) of the
American SSRC (Structural Stability Research Council) will be used.
The available SRC design codes are as follows
:
- The allowable stress design
of the American SSRC (Structural Stability Research Council) (SSRC79)
(available upon request)
Revision of Gen 2012
-
Taiwan SRC Design Specifications and Commentary of Buildings (TWN-SRC100)
- Taiwanese SRC Design Specifications
and Commentary of Buildings (TWN-SRC92)
- China Standard (JGJ138-01)
- Structure Design Code
of the Architectural Institutes of Japan(AIJ-SRC01)
- Structure Design Code
of the Architectural Institutes of Korea (AIK-SRC2K)
Note 2
The allowable stress design of the American SSRC (SSRC79) and the SRC Structure
Design Specifications of the Architectural Institute of Korea (AIK-SRC2K)
can be applied for SRC composite column members.
Design Code
: Enter the selection
and close the dialog box.
: Do not enter the selection
and close the dialog box.
Revision of Gen 2012