Click to the right of General Spring Supports: Display the General Spring Support Table.
Boundary Group Name
Select a Boundary Group in which the specified boundary condition is included. Select "Default" if Group assignment is unnecessary. Click to the right to prompt the "Define Boundary Group" dialog box to add, modify or delete Boundary Groups.
Options
Add/Replace: Enter or replace new general nodal spring stiffness of selected nodes
Delete: Delete previously entered general nodal spring stiffness of selected nodes
General Spring
General Spring Type
Select general nodal spring type to be entered from the previously defined general spring support.(Refer to "Define General Spring Type")
Click to the right to display the General Spring Type dialog box.
Stiffness
SDx: Spring stiffness in GCS x-direction (or node's local x-direction when defined)
SDy: Spring stiffness in GCS y-direction (or node's local y-direction when defined)
SDz: Spring stiffness in GCS z-direction (or node's local z-direction when defined)
SRx: Rotational spring stiffness about GCS x-axis (or node's local x-axis when defined)
SRy: Rotational spring stiffness about GCS y-axis (or node's local y-axis when defined)
SRz: Rotational spring stiffness about GCS z-axis (or node's local z-axis when defined)
Note
The above 6 spring stiffness values represent only the 6 diagonal terms in the 6 x 6 stiffness matrix entered in General Spring Type.
Mass: When the mass matrix is defined in Define General Spring Type, "Considered" is displayed. When there is no mass matrix defined, "None" is displayed.
Damping: When the damping matrix is defined in Define General Spring Type, "Considered" is displayed. When there is no damping matrix defined, "None" is displayed.
|