Load Set
Select the Load Set
under which the Line Load has to be assigned . Click to invoke the Define Load Set dialog to Add,
Modify or Delete Load Set(s).
Load
Type
Point
Load
Concentrated force and
moment.
Distributed
Load
Uniformly/linearly varied
and full/partial distributed load.
Position
Specify the location
of the load.
Select
Curve
Select curves to apply
load.
LX
Distance from the left
end of the curve to the start point of the Line Load.
RX
Distance from the right
end of the curve to the end point of the Line Load (activated only for
Distributed Load).
Type
Activated in case of
Point Load.
Force
Moment
Direction
The direction of load
is deactivated if the load is moment.
Normal
Direction
Global
X
Global coordinate X-Axis.
Global
Z
Global coordinate Z-Axis
(only Global Z can be entered if the Line Load is Distributed type).
Value
Define the magnitude
of load.
Point
Load+Force
F (kN)
Point
Load+Moment
M (kN.m)
Distributed
Load
w1, w2 (kN/m)
Click Preview to check the created Line Load.
The dialog box will be initialized.
After creating the load, the dialog box will close upon clicking.
Click the ESC key to close the dialog box.
After creating the load, the work process
will switch to the state of Select Curve upon clicking.
|