Beam                                                                                                                                                                                       

Create Beam member(1D).

 

▒ Call

New

[Member] Tab > [1D Member] > [Beam] > [Beam]

Delete

Work Tree [Model] Tab > [Member] > [Member Set] > [Beam] > [List] > Right-Click > [Delete]

 

▒ Detail Description

3D Modeling Mode (Default)

< Member Settings &  Insert Coordinates >

 

Member Set : Select Member Set.

Story Set : Select Story Set.  

Section : Select Section Property.

Enter the coordinates of start and end points of member.

  (Relative Coordinate) : Define the coordinates of end point as relative coordinates of start point.

Story Mode

< Member Settings &  Insert Coordinates >

 

   By Line Segment Select : Create Beam by selecting Center Layer Line of Cad Tracing. Note that Center Layer Line is selected with line unit where they intersect each other.
   By Line Select : Create Beam by selecting Center Layer Line of Cad Tracing
   By Draw : Create Beam by selecting two points.