Remove: Hole

Function

Hole removes holes from selected surfaces.

Call

Geometry > Remove > Hole

<Remove Hole>

Select Target Surface(s)

Select target surfaces on which holes to be removed exist.
 

Select Hole(s)

Select holes to be removed.  There are five ways to select the holes automatically.  Sub-faces, which are completely contained within shells, are not automatically selected.  Only the through-holes are automatically selected.  Sub-faces that are completely within shells can be selected directly on the screen, and the holes can be removed as well.  However, the sub-faces remain after the operation, thereby remaining overlapped.
 

Find

After selecting one of the following five options and pressing the Find button, the program automatically finds and selects the holes.

All

Select all the holes that can be selected automatically.
Radius

Select holes whose radii are smaller than the specified radius.  It is applicable only when the holes are circular.
Perimeter

Select holes whose perimeters are smaller than the specified perimeter length.
Area

Select holes whose areas are smaller than the specified area.
Diagonal Length

Select holes whose diagonal lengths are shorter than the specified diagonal length.  If a hole is not rectangular, then the bounding box is used as the reference for the diagonal length.