Analysis Case | ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
Create Analysis Cases. Analysis can be carried out for each Analysis Case. Applicable Modules:
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
From the Main Menu,
select Analysis
| Design > Analysis
Control > Analysis Case (Slope
Module), select Analysis | Design > Design and Report >
Analysis Case (Seepage
Module) From the Main Menu,
select Boundaries
| Analysis > Analysis
Control > Analysis Case (Dynamic
Module) From the Main Menu,
select Loads
| Boundaries | Analysis > Analysis Control > Analysis Case From the Command Line, type 'AnalysisCase' or 'AC' | ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
|
, 'Add/Modify Analysis
Case' window will open up.|
Tunnel |
Slope |
Soft Ground |
Foundation |
Seepage |
Dynamic |
|
Static Nonlinear Analysis |
Slope Stability (SRM) Analysis |
Consolidation (FEM) Analysis |
p-y Nonlinear Analysis |
Seepage (Steady Flow) Analysis |
Eigenvalue Analysis |
|
Construction Stage Analysis |
Slope Stability (SAM) Analysis |
1D Consolidation Analysis |
|
Seepage (Transient Flow) Analysis |
Response Spectrum Analysis |
|
|
Slope Stability (LEM) Analysis |
Construction Stage Analysis |
|
Construction Stage Analysis |
Time History Analysis |
|
|
Construction Stage Analysis |
|
|
|
Ground Response Analysis |
|
|
|
|
|
|
Equivalent Linear Analysis |
Analysis Control Data
Click 
to
the right to set details of Analysis Control.
Analysis by each Load Set in the Analysis Model
Analyze the model individually for each Load Set and compile the results accordingly for each Load Set.
Define Analysis Model
Define elements, boundaries and loadings to be used in Analysis in which each Set can be Added and Deleted individually.
Use all Mesh Sets
Use all the Mesh Sets in the Analysis model.
Use all Boundary Sets
Use all the Boundary Sets in the Analysis model.
Use all Load Sets
Use all the Load Sets in the Analysis model.
All Input Data
All the Mesh, Boundary and Load Sets which have been defined are listed.
Data used in Analysis
Drag and drop Mesh, Boundary and Load Sets to be used in analysis from the Set Tree (All Input Data) into the Analysis Set Tree box.
Click to modify the Analysis Case data.
Click to delete the Analysis Case data.
Click the ESC key to close the dialog box.