Circle

Create Circle(s) for geometry modeling.

If a curve is selected to draw a Circle, Structural Properties can be assigned and 1D mesh can be created.  If a closed domain or a converted Surface is selected, Ground Material Properties can be assigned and 2D mesh can be created. After the generation of mesh, Loads/Boundaries can be assigned to Circle(s), which are applied to Nodes/Elements.

Applicable Modules:

From the Main Menu, select Geometry > Create > Circle

From the Command Line, type 'Circle' or 'C'

CIRCLE Specify center point: Select the center point of the Circle or enter the coordinates.

Specify radius of circle: Enter the radius of the Circle.