ERROR [2128]: MULTI-BODY SYSTEM SEEMS TO BE OVER-CONSTRAINED

Cause

When using a joint element in linear analysis, this error is generated if the constraints defined by the joint element have been duplicated.

Analysis Type

Static/dynamic rigid body analysis (multi-body system)

Related Menu

[Not Applicable in FEA NX]

Dynamic/Trans.Heat/CFD Analysis >> MBS >> Joint...

Remedy

Typically, if 2 or more master joints are connected to a slave joint of a joint element, the constrains are duplicated.  Properly modify the joint element to avoid any duplicated definitions of the constraints.