Specify Allowable Stress
| ||
| ||
| ||
Use this function to enter the allowable stress coefficients. Often, the user may wish to define the allowable stresses rather than using the values calculated according to the applied design code during the strength verification of steel members. The coefficient values entered are ratios to the yield strength (Fy) of the relevant steel material. | ||
| ||
| ||
| ||
From the Main Menu select Design > Steel Design Parameter > Specify Allowable Stress.
From the Menu tab of the Tree Menu select Design > Steel Design Parameter > Specify Allowable Stress. | ||
| ||
| ||
First, select the members in the model and enter the following :
Option
Select Add/Replace or Delete.
Add/Replace: Add the newly entered values or replace the previously entered values.
Delete: Delete the entered values. Data entry is not required when deleting.
: Apply the entered values to the selected members.
: Close the entry Dialog Bar.
Note
1
Note
2
Note
3
Note
4
Note
5
Note
6
Note
7
Access the data table following the procedure below.
From the Main Menu select Design > Steel Design Parameter > Steel Design Tables > Specify Allowable Stresses. From the Tables tab of the Tree Menu select Design Tables > Steel Design Table > Specify Allowable Stresses.
| ||
|