Circle | ||||||
|
| ||||||
|
| ||||||
|
Create Circle(s) for geometry modeling. If a curve is selected to draw a Circle, Structural Properties can be assigned and 1D mesh can be created. If a closed domain or a converted Surface is selected, Ground Material Properties can be assigned and 2D mesh can be created. After the generation of mesh, Loads/Boundaries can be assigned to Circle(s), which are applied to Nodes/Elements. Applicable Modules:
| ||||||
|
| ||||||
|
| ||||||
|
| ||||||
|
From the Main Menu,
select Geometry
> Create > Circle From the Command Line, type 'Circle' or 'C' | ||||||
|
| ||||||
|
| ||||||
|
CIRCLE Specify center point: Select the center point of the Circle or enter the coordinates. Specify radius of circle: Enter the radius of the Circle.
| ||||||
|
|
